
Tja, ni har v�l f�rmodligen l�st dom.
Men f�r s�kerhets skull skriver jag dom som st�r i manualen och tar inte fr�n n�gon
annan sida!
Jag antar att ni kan lite engelska och
skriver d�rf�r s�, vissa saker kan vara lite kluriga att �vers�tta...

Engine
Type..............................................two-strokes
single cylinder
by
lamellar suction and electronic
controlled
C.T.S. valve on the exhaust
Cooling..........................................by
liquid
Bore...............................................mm 56
Stroke............................................mm 50.6
Piston Displacement...................cm� 124.63
Compression Ratio
(at closed ports)............................10,2:1
Starting .........................................electric

Lubrication
Engine............................................by
automatic mixer
Primary drive transmission/
Gearbox..........................................by oil contained
in
the crankcase

Ignition
Type.................................................Electronic
C.D.I.
Ignition Timing (piston stroke)...1.85 mm
B.T.D.C. (Mikuni carburetor); 1.55 mm
B.T.D.C. (Dell'Orto carburetor)
Spark Plug Type
(in alternative)................................"NKG" BR9 EG,
Champion
QN 84
Gap...................................................mm 0.6

* Carburetor
Type...........................................................Dell'Orto
PHBH 28 RD
Venturi Diameter....................................mm 28
High Speed Jet.........................................130
Power Jet...................................................98
Starter Jet..................................................65
Low Speed Jet...........................................50
Emulsifier..................................................B50
Throttle Piston.......................................... .40
Metering Pin.............................................X 71
Metering Pin position..............................2nd
Main Nozzle...............................................266 EM
Float............................................................g 6,5
Idle Mixture Adjusting Screw.................2
* Carburetor
Type..........................................................."MIKUNI"
TM 35
Venturi Diameter....................................in. 1.38
High Speed Jet.........................................225
Low Speed Jet...........................................45
Throttle Piston.......................................... .5.5
Metering Pin.............................................6AEL4-60
Metering Pin slot......................................4th
Float............................................................g 6,6
Idle Mixture Adjusting Screw (turns)....1 and 1/2
*: In alternative

Primary Drive
Drive pinion Gear......................................z 22
Clutch ring Gear........................................z 72
Ratio............................................................3.272

Transmission
Type.............................................................constant
mesh gear
Ratios:
1st................................................................2.727 (30/11)
2nd...............................................................1.812 (29/16)
3rd................................................................1.352 (23/17)
4th................................................................1.105 (21/19)
5th................................................................0.956 (22/23)
6th................................................................0.863 (19/22)
7th................................................................0.818 (18/22)

Secondary Drive
Transmission sprocket..............................z 14
Rear Wheel Sprocket.................................z 41
Ratio.............................................................2.928
Chain............................................................5/8"x1/4"

Final Ratios
1st..................................................................26.139
2nd.................................................................17.372
3rd..................................................................12.967
4th..................................................................10.593
5th...................................................................9.168
6th...................................................................8.277
7th...................................................................7.842

Frame
Type.........................twin-beam with extruded
tubes
and cast aluminium parts.
Tailpiece
made in square section steel tubes.
Steering
damper.

Front Suspesion
Type.........................telescopic-hydraulic fork
reversed
rods.
Rods �
40 mm.
Stroke
on the legs axis 120 mm.

Rear Suspension
Type.........................variable flexibility SOFT DAMP
with
hydrualic single damper
and
adjustable preload spring -
Wheel
stroke 133,5 mm.

Front Brake
Type..........................fixed disc �
320 mm
with
hydraulic control; floating caliper

Rear Brake
Type..........................fixed disc �
230 mm
with
hydraulic control; floating caliper

Front Rim
Type..........................in light alloy
Size............................2.75"x17"

Rear Rim
Type..........................in light alloy
Size............................4.00"x17"

Front Tire
Make and
type............................"Michelin" ZR 17 HI - SPORT-T
or
"Michelin" ZR 17-TX 15
Tire size....................110x70x17"
Cold tire pressure
driver only................Kg/cm� 1,9 psi 27
Cold tire pressure
with passenger........Kg/cm� 2,0 psi 28.4

Rear Tire
Make and
type............................"Michelin" ZR 17 HI - SPORT-T
or
"Michelin" ZR 17-TX 25
Tire size....................150x60x17"
Cold tire pressure
driver only................Kg/cm� 2,0 psi 28,4
Cold tire pressure
with passenger........Kg/cm� 2,2 psi 31,3

Dimesions, Weight, Capacities
Wheelbase.........................................mm 1375
Overall length...................................mm 1980
Overall width (mirrors)....................mm 760
Overall height....................................mm 1100
Saddle height driver.........................mm 760
Saddle Height passenger.................mm 945
Minimum ground clearance.............mm 150
Dry Weight..........................................Kg 129
Fuel Tank capacity.............................l 14
Fuel reserve (fixed pilot light)...........l 6
Oil tank capacity.................................l 0,80
Crankcase oil.......................................l 1.5
Oil in each fork rod.............................420 cc
